You could try disconnecting the battery for a few minutes to reset the immobilizer in case it's got into a knot due to the slow discharge its had. Then lock and unlock the car to set and unset the immobilizer. Having run into a very similar problem yesterday as dodger described I googled it up and found this thread.
Sit inside and close all the doors. Turn the key in the ignition till the lights on the dash come on and press one of buttons on the key fob until the car locks and unlocks. That will identify the key has been recoded to the car. Turn the ignition so all the lights go off and retry to start car. Quote. Ford Focus ST MK2 2007. Hello! I really need help if anyone knows what to do. One day my car suddenly didn't start and the PATS light was blinking in the middle. The fuelpump is hearable, everything inside the car is working except turning the engine. No crank is happening while turning the key. When the alarm is reset, the unit will sound 4 loud chirps if the alarm had triggered during the alarm set mode. 11) STARTING When the alarm is reset the vehicle after dash led will be off, the vehicle THE VEHICLE To start the the alarm has been reset. can be started within 60 seconds. After 60 seconds the immobiliser will be armed, dash led on.
To reset the anti-theft system on a Ford Escape, put the key into the ignition and activate the electrical systems, but leave the engine turned off. Wait anywhere from two to 10 minutes then take the key out of the ignition—your theft prevention system should be reset.
Try this first. Step 1: take off outer layer around the steering wheel Step 2: take off any foam if any Step 3: disconnect the immobiliser wire and reconnect it Step 4: test. Resetting the Hi there , thanks for replying Ok I suspect the vehicke has been jump started from your description of the issue If the battery is completley dead and a voltage pack /leads are used it causes a spike in the system The first thing to check is the power train /engine management fuses The mist common fuse to blow is the 3 amp (violet fuse ) in the battery junction box( in the engine bay ) Check The 4D ID60 on ebay says fiesta, but it lists the following: New Virgin ceramic Transponder chip 4D ID60. The chip will need programming by a group dealer or by the locksmith - chip can be programmed only ONCE! The Chip is compatible with the following models: Ford Fiesta 2001-2002. Ford Connect 2002-. Ford Focus 1998-2004. To complete the body control module reset, you will have to reconnect the battery. This reestablishes the electrical supply through the BCM as well as other electrical peripherals of the vehicle. Once the battery is reconnected, check if the problems that made you perform the body control reset have been rectified. Ax26Yw.
  • xr3fgi97ut.pages.dev/792
  • xr3fgi97ut.pages.dev/624
  • xr3fgi97ut.pages.dev/585
  • xr3fgi97ut.pages.dev/636
  • xr3fgi97ut.pages.dev/13
  • xr3fgi97ut.pages.dev/92
  • xr3fgi97ut.pages.dev/61
  • xr3fgi97ut.pages.dev/534
  • xr3fgi97ut.pages.dev/80
  • xr3fgi97ut.pages.dev/507
  • xr3fgi97ut.pages.dev/870
  • xr3fgi97ut.pages.dev/372
  • xr3fgi97ut.pages.dev/805
  • xr3fgi97ut.pages.dev/500
  • xr3fgi97ut.pages.dev/376

    • how do i reset my ford focus immobiliser